Chapter 6: Supporting procedures

Overview

Purpose

This chapter contains supporting procedures for the Alcatel-Lucent 1665 Data Multiplexer Extend.

Contents

Before you begin

Procedure 6-1: Install software on the PC

Procedure 6-2: Connect Personal Computer (PC) and establish WaveStar^® CIT session

Procedure 6-3: Replace high-speed main OLIU circuit pack

Procedure 6-4: Replace low-speed function unit OLIU circuit pack

Procedure 6-5: Replace pluggable transmission module

Procedure 6-6: Replace DS1/DS3/16/3 (LNW39/LNW391), 3DS3 (LNW111), or 16DS1 (LNW112) circuit pack

Procedure 6-7: Replace DS3/EC-1/TMUX circuit pack

Procedure 6-8: Replace DS1 (LNW6/LNW7/LNW8/LNW801) circuit pack

Procedure 6-9: Replace Ethernet/Data circuit pack

Procedure 6-10: Upgrade or replace SYSCTL (LNW2) circuit pack

Procedure 6-11: Clean optical fibers, dual LC adapters and LC lightguide buildouts (LBOs)

Procedure 6-12: Clean optical pluggable transmission module

Procedure 6-13: Install/remove LC lightguide buildouts (LBOs)

Procedure 6-14: Connect OLIU optical loopbacks

Procedure 6-15: Replace fan filter

Procedure 6-16: Ugrade software generic via SFTP

Procedure 6-17: Upgrade software generic via FTP

Procedure 6-18: Upgrade software generic via FTTD

Procedure 6-19: Upgrade software generic via FTAM

Procedure 6-20: Apply software generic

Procedure 6-21: Backup and restore NE database via FTP

Procedure 6-22: Backup and restore NE database via FTTD

Procedure 6-23: Backup and restore NE database via FTAM

Procedure 6-24: Observe FTP progress

Procedure 6-25: Disable an FTP server on your PC

Procedure 6-26: Establish communications with network element

Procedure 6-27: Enter/exit pluggable transmission module maintenance state

Procedure 6-28: Replace DWDM optical multiplexer/demultiplexer circuit pack

Procedure 6-29: Replace 10G Muxponder circuit pack

Procedure 6-30: Verify spanning tree configuration