Procedure 5-108: Clear "SYS generic corrupted" alarm
Before you begin
Prior to performing this procedure:
-
Refer to Before you begin and Required equipment in this chapter.
-
Refer to Electrostatic discharge in Chapter 1, Safety.
Steps
Complete the following steps to clear a SYS generic corrupted alarm.
1 |
Important! The software apply operation has been interrupted/failed. From the System View, select Configuration → Software → Apply Software to reschedule another Smart or Smart, Override Alarms software apply. Result: Approximately 15 minutes after the scheduled Smart apply time, the apply is complete. You will be logged off the system when the system resets. A flashing b in the IND display on the SYSCTL indicates that a boot is in progress. During the boot, the b may extinguish for up to 20 seconds and then resume flashing. Reference: Procedure 6-20: Apply software generic | ||||||
2 |
Did the software apply operation complete successfully?
| ||||||
3 |
From the System View, select Configuration → Software → Apply Software to schedule a Forced software apply. Result: Approximately 15 minutes after the scheduled Forced apply time, the apply is complete. You will be logged off the system when the system resets. A flashing b in the IND display on the SYSCTL indicates that a boot is in progress. During the boot, the b may extinguish for up to 20 seconds and then resume flashing. Reference: Procedure 6-20: Apply software generic | ||||||
4 |
Did the Forced software apply operation complete successfully?
| ||||||
5 |
When the system reset is complete, log back into the network element. Reference: Procedure 6-2: Connect Personal Computer (PC) and establish WaveStar® CIT session End of steps |