Procedure 5-103: Clear "RPR Topology Map Entry Invalid" condition
Before you begin
Prior to performing this procedure:
-
Refer to Before you begin and Required equipment in this chapter.
-
Refer to Electrostatic discharge in Chapter 1, Safety.
Steps
Complete the following steps to clear the RPR Topology Map Entry Invalid condition.
1 |
From the WaveStar® CIT System View, click the Alarm List button and locate the RPR Topology Map Entry Invalid condition in the resulting alarm list and note the corresponding VCG AID. |
2 |
From the System View, select Configuration → Equipment. Expand the required Ethernet circuit pack, select the affected VCG, and click Select. Click the Timer tab and increase the Topology Stability Timer (msec) according to local procedures. Click Apply, read the warning message, then click Yes to execute the command. Click Close to exit. |
3 |
From the System View, click the Alarm List button and click Refresh. If the RPR Topology Map Entry Invalid condition is still present, repeat Step 2 and Step 3. End of steps |