From the WaveStar^® CIT System View, click the Alarm List button and locate the unrecoverable hardware failure during download, replace CP alarm in the resulting alarm list.

Refer to the Probable Cause column in the alarm list, and note the corresponding AID.

Replace the affected circuit pack.

Result:

The unrecoverable hardware failure during download, replace CP alarm clears when the circuit pack is removed from the slot. Except for the LNW6, LNW7, and LNW16 circuit packs, the software download begins to the next circuit pack when the alarm clears. For LNW6, LNW7, and LNW16 circuit packs, the software download did not stop. When the circuit pack failed, the software download continued to the next circuit pack.

Reference:

Refer to the appropriate circuit pack replacement procedure in Chapter 6, Supporting procedures.

Is the affected circuit pack an LNW6 28DS1, LNW7 28DS1PM, or LNW16 12DS3EC1 circuit pack?

After the initial software download is complete, select Configuration → Software → Apply Software to schedule a Smart, Override Alarms software apply to the replacement LNW6, LNW7, or LNW16 circuit pack.

Result:

Approximately 15 minutes after the scheduled apply time, the apply is complete. You will be logged off the system when the system resets.

A flashing b in the IND display on the SYSCTL indicates that a boot is in progress. During the boot, the b may extinguish for up to 20 seconds and then resume flashing.

Reference:

Procedure 6-20: Apply software generic

After the system reset is complete, log back into the shelf.

End of steps