Procedure 16-4.11: Configure Maintenance Association End Point (MEP) VSF
Overview
Use this procedure to show/activate Vendor Specific Fault (VSF) processing on a Down-MEP. It enables receiving proprietary VSF frames which carry remote fault information for the MEP’s port. The MEP must already be created using MEP Configuration.
Step
1 |
From the Navigation menu, select Service OA&M → Maintenance Association End Point → VSF Configuration. Equivalent CLI command: ethoam vsf. Result: The MEP VSF Configuration window displays. |
2 |
Enter the parameters as required. See Table 16-12, MEP VSF Configuration parameters. |
3 |
Click Submit to enable VSF processing for the selected MEP. Click Delete to disable VSF processing for the selected MEP. End of steps |
MEP Configuration parameters
Table 16-12: MEP VSF Configuration parameters
|
Parameter |
Description |
CLI command |
|---|---|---|
|
MD Name |
A drop-down list containing all MDs in the system. There is no default value. |
show ethoam md <MDname> |
|
MA Name |
Maintenance Association Name. This is a dropdown list containing all valid MAs in the selected MD. |
show ethoam ma <MAname> |
|
MEP ID |
This is a drop-down list containing all MEP IDs for the selected MD/MA. The default value is the first MEP ID in the selected MD/MA above. |
show ethoam mep <mepid> |
|
VSF Status |
The VSF processing status for the selected MD/MA/MEPID above. It is display only. |
show ethoam vsf md |