OAM-PM Bins (NSP) report

OAM-PM Bins (NSP) report overview

The OAM-PM Bins (NSP) report differs from the OAM-PM Bins report by including OAM data for NEs managed by the NFM-P and MDM (model-driven Nokia NEs). The report shows a distribution count of the PM bins in use. To use this report, a bin policy must be distributed, PM sessions must be configured for each bin, and PM sessions must be active and enabled.

Use cases

SLA reporting—Identify potential impact to service level agreements.

QoS analysis—Identify potential performance impact for a selected bin group.

Prerequisites

The following sessions need to be performed in the NSP and NFM-P for the report to be created:

a DMM session must be defined with accounting enabled in both the MDM-managed and NFM-P NEs
a TWAMP-Light session must be defined with accounting enabled in both the MDM-managed and NFM-P NEs
You must enable aggregation using NSP. For more information, see the Telemetry information on the Network Developer Portal and the NSP Data Collection and Analysis Guide.

Report inputs

The following table shows the report inputs.

Table 17-3: OAM-PM Bins (NSP) report inputs

Prompt	Notes
Session Type	ETH-CFM Session, TWAMP-Light Session
End Date	Calendar date or relative date (for example, two days ago) and time
Granularity	Aggregation types: Hourly Daily Monthly Raw Collection Interval
Report range	Length of time to be reported, in hours, days, or months
Session name	Search using partial names, full names, or IP addresses.
Bin Type	Bin types as configured in the NSP and NFM-P
Interval Duration	5 minutes, 15 minutes, 1 hour, or 1 day
Logo resource ID	The logo to add to the report. Enter the Resource ID of the logo image in the Images folder. The default is the Nokia logo. To create the report without a logo, leave the Logo Resource ID field blank.
Logo Position	Choose Left, Middle, or Right. The logo appears on the left on the first page of the report if you choose Left or Middle.
Show Report Output On One Page	Select the check box to enable pagination. Note: Using the Show report on one page option when creating reports as drill-downs may impact report rendering time. Nokia recommends disabling the Show report on one page option when creating reports.

Report characteristics

The following table lists the principal report characteristics.

Table 17-4: OAM-PM Bins (NSP) report characteristics

Characteristic	Value
Data type	OAM testing
Source database	Auxiliary database
NE types supported	all 7750 SR variants all 7450 ESS variants all 7950 XRS variants 7210 SAS-M 24F, 7210 SAS-M 24F 2XFP, 7210 SAS-M 24F 2XFP ETR, 7210 SAS-Mxp, 7210 SAS-T 12F 10T 4XFP, 7210 SAS-T 12F 10T 4XFP ETR, 7210 SAS-X 24F 2XFP, 7210 SAS-K, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-S/SX 1/10GE VC
Aggregation types	—
Drill-down support	No

Example

The following figure shows a report example.