How do I create a Wavence VPRN service?

Purpose

Use this procedure to create a Wavence VPRN service. The parameters that are available to you is dependant on the intent type that is associated with the service template you select, and may differ from those described in this procedure, which assumes the Nokia-provided Wavence VPRN template is being used.

Note: For Wavence VPRN services, validations from NFM-P are not propagated to NSP. For all the validation or error messages that correspond to service failures seen in NSP, the user should refer to the NFM-P logs.

Steps

Perform How do I create a service template?.

From the Service Management, Services view, click + CREATE.

The Select a service template to start form opens displaying a list of service templates.

Click on a Wavence VPRN service template from the list.

The Create Service form opens with the Template Name parameter populated.

Configure the parameters, as required:

Parameter	Description
Service Name	Specifies the name of the service. Must be unique from other services created using NSP.
Customer ID	Specifies the customer ID
Description	Describes the service
NE Service ID	Specifies the NE service ID

In the Site Details panel, click + ADD.

The Add Site form opens.

Configure the parameters, as required:

Parameter	Description
Site	Specifies the site to be used
VRF Name	Specifies the name of the VRF
Description	Describes the site
MTU	Specifies the MTU of the service
Auto Bind Tunnel
Resolution	Specifies the MBS of the queue

In the Interface Details panel, click + ADD.

The Add Interface form opens.

Configure the parameters, as required:

Parameter	Description
Interface Name	Specifies the name of the interface
Description	Describes the interface
IPv4/IPv6
Address	Specifies the primary IPv4/IPv6 address assigned to the interface
Prefix Length	Specifies the primary IPv4/IPv6 address prefix length
SAP
Port ID	Specifies the port to be used
Outer VLAN Tag	Specifies the outer VLAN tag
Description	Describes the SAP

Click ADD to add the interface. The Add Interface form closes.

In the Static Route Details panel, click + ADD.

The Add Static Routes form opens.

Configure the parameters, as required.

Parameter	Description
IP Prefix	Specifies the IP prefix for the static route
Prefix Length	Specifies the prefix length for the static route
Is Blackhole	Specifies whether the prefix is a blackhole route

Click ADD to add the static route. The Add Static Route form closes.

Click ADD to add the site.

The Add Site form closes.

In the SDP Details panel, click + ADD.

The Add SDP form opens.

Configure the parameters, as required:

Parameter	Description
Source Device ID	Specifies the SDP source device identifier
Destination Device ID	Specifies the SDP destination device identifier
Ingress and Egress Label	Specifies the Ingress/Egress Label used by the Wavence node
SDP ID	Specifies the SDP identifier
VC ID	Specifies the SDP virtual circuit identifier

Click ADD to add the SDP binding. The Add SDP form closes.

Perform one of the following:

Select the Reserve Resources check box and click PLAN to create the service in a Planned state.
Click SAVE to create the service in a Saved state.
Click DEPLOY to create the service in a Deployed state.

See What is Life Cycle State? for more information.

End of steps

Use subject to agreed restrictions on disclosure and use.