To assign an ICMP ping template to a VPRN L3 access interface
Before you begin
ICMP ping templates are used to populate values for ICMP ping tests when the tests are used on L3 interfaces to control the operational state. ICMP ping templates are supported for IPv4 only. See To configure an ICMP Ping template for information about configuring ICMP ping templates.
Note: Nokia recommends that you assign an NE DoS protection policy, configured with a protocol of ICMP-Ping-Check, to the affected interfaces; see To assign an NE DoS or DDoS protection policy to a VPRN L3 access interface.
Steps
1 |
Choose Manage→Service→Services from the NFM-P main menu. The Manage Services form opens. |
2 |
Choose a VPRN service and click Properties. The VPRN Service (Edit) form opens. |
3 |
On the service tree, expand Site→L3 Access Interfaces, right-click on the L3 access interface you need to modify, and choose Properties. The VPRN L3 Access Interface (Edit) form opens. |
4 |
Click on the ICMP Ping Template tab. |
5 |
Click Create, or choose the template in the list and click Properties. The Virtual Interface ICMP Template Config form opens. |
6 |
Click Select to choose a template pointer for the template. The Select Template Pointer form opens. |
7 |
Choose an ICMP Ping template from the list and click OK to close the Select Template Pointer form. |
8 |
On the Virtual Interface ICMP Template Config form, configure the Admin State and Destination Address parameters for the ICMP Ping test. |
9 |
Save the changes and close the forms. End of steps |