To configure an ICMP Ping template
Before you begin
ICMP ping templates are used to populate values for ICMP ping tests when the tests are used on L3 interfaces to control the operational state. ICMP ping templates are supported for IPv4 only.
Using the NFM-P policy framework, ICMP ping templates are assigned to L3 interfaces for IES and VPRN services; see the following procedures:
-
To assign an ICMP ping template to an IES L3 access interface
-
To assign an ICMP ping template to a VPRN L3 access interface
Nokia recommends that you assign an NE DoS protection policy configured with ICMP-Ping-Check as the protocol to the affected interfaces; see To assign a DoS protection policy or DDoS protection policy to an IES L3 access interface and To assign an NE DoS or DDoS protection policy to a VPRN L3 access interface.
Steps
1 |
Click Tools→OAM Templates→ICMP Ping Template on the NFM-P main menu. The ICMP Ping Template form opens. |
2 |
Click Create, or select an existing template and click Properties. The ICMP Ping Template (Create|Edit) form opens. |
3 |
Configure the required parameters. |
4 |
Click OK to save the policy and close the form, or click Apply to save the policy. |
5 |
Perform To release and distribute a policy to distribute the policy to NEs. End of steps |