To create an MPLS-TP LSP
Purpose
Use the procedure to create an MPLS-TP LSP. This procedure requires the existence of a numbered or unnumbered L3 network interface on the NE that hosts the MPLS-TP instance. See NE routing and forwarding for more information about how to configure network interfaces.
Steps
1 |
Choose Manage→MPLS→MPLS-TP LSPs from the NFM-P main menu. The Manage MPLS-TP LSPs form opens. |
2 |
Click Create and choose Create LER TP-LSP. The LER TP-LSP (Create) form opens. |
3 |
Configure the required parameters in the Identity and Destination panels. The TP-LSP ID must be in the range of the TP-LSP ID Minimum and TP-LSP ID Maximum parameters that you specified in Step 3 of To configure MPLS-TP on a routing instance . |
4 |
Click Select in the Source Site panel and choose a source site and click OK. |
5 |
Click on the TP-LSP Path tab and click Create. The MPLS-TP LSP Path (Create) form opens. Note: You can create one working path and one protecting path per LSP. As required, repeat Step 5 to Step 12 to create the alternate path type. |
6 |
Configure the required parameters. |
7 |
Click Select in the Out-Link panel and choose an interface and click OK. See To create an MPLS interface for information about how to configure MPLS interfaces. |
8 |
Click on the Path MEP tab and click Create. The Path MEP (Create) form opens with the General tab displayed. |
9 |
Configure the required parameters. |
10 |
As required, click Select in the Proactive OAM Template panel and choose a template and click OK. See To configure MPLS-TP on a routing instance for information about how to create a Proactive OAM Template. |
11 |
As required, click Select in the Protection Template panel and choose a template and click OK. See To configure MPLS-TP on a routing instance for information about how to create a Protection Template. |
12 |
Save your changes and close the forms. End of steps |