|
|
1 | Before you can create an MPLS service tunnel, you must create a static LSP, dynamic LSP or segment routing TE LSP. See the following procedures:
|
2 |
Create an IP/MPLS service tunnel and assign it to an NE as follows:
-
Create an IP/MPLS service tunnel; see
To create an IP/MPLS service tunnel .
-
Create an IP/MPLS service tunnel using a tunnel template. See
To create an SDP using a tunnel template .
Note: Service tunnels are unidirectional, so they are required in both directions between the source NE and the destination NE.
-
Create a tunnel administrative group and a tunnel selection profile and assign the tunnel selection profile to an SDP binding. See
To create a tunnel administrative group and
To create an IP/MPLS service tunnel and
To create a tunnel selection profile for more information.
|
3 |
Create an L2TPv3 tunnel and assign it to an NE as follows:
-
Create an L2TPv3 tunnel; see
To configure an L2TPv3 service tunnel .
-
Create an L2TPv3 service tunnel using a tunnel template. See
To create an SDP using a tunnel template .
Note: Service tunnels are unidirectional, so they are required in both directions between the source NE and the destination NE.
|
4 |
Perform one of the following to create an Ethernet service tunnel:
-
Create an Ethernet service tunnel endpoint. See
To configure an Ethernet tunnel endpoint .
-
Create an Ethernet service tunnel and assign endpoints to the tunnel. See
To configure an Ethernet tunnel .
|
5 |
Create transit services on Ethernet rings as required. See
To configure a transit service on an Ethernet ring .
|
6 |
As required, discover and list service tunnel information. See
To discover service tunnels and
To discover flow-through services .
|
7 |
Perform one of the following to view service tunnel information:
-
View and manage service tunnels and tunnel elements. See
To view and manage service tunnels and tunnel elements .
-
View the service tunnel topology. See
To view the service tunnel topology .
|
8 |
As required, run an OAM validation test on a service tunnel. See
To run an OAM validation test on a service tunnel . |