To create and run a CFM single-ended loss OAM diagnostic test from the STM
Steps
1 |
Choose Tools→Service Test Manager (STM) from the NFM-P main menu. The Service Test Manager form opens. |
2 |
Click Create and choose Ethernet CFM→CFM Single Ended Loss Test. The CFM Single Ended Loss Test (Create) form opens. |
3 |
Configure the required parameters. |
4 |
Select a global MEG in the Test Object panel. |
5 |
Select an originating MEP in the Test Object panel. Note: MEPs can be added to services automatically or manually. If no MEPs are listed when you perform this step, see Ethernet CFM for information about how to configure a MEP that is required for this step. |
6 |
To select a MEP as the test destination, click Select MEP. |
7 |
Configure the required parameters in the MEP Transmit LMM Information panel. |
8 |
Save the changes and close the forms. |
9 |
To run the OAM diagnostic test and view the results, perform To run one or more OAM diagnostic tests from the STM and view the test results . See To interpret OAM diagnostic test results on the STM for information about how to interpret the test results. End of steps |