To create and run an MTU ping OAM diagnostic test from a service tunnel
Steps
Use the MTU ping diagnostic test to find the largest valid frame size.
1 |
Choose Manage→Service Tunnels from the NFM-P main menu. The Manage Service Tunnels form opens. |
2 |
Filter to list only the source and destination routers of the service tunnel and click Search. The list of service tunnels appears. |
3 |
Double-click on a service tunnel from the list. The Tunnel (Edit) form opens. |
4 |
Click on the Tests tab. |
5 |
Click on the MTU Ping tab. |
6 |
Click Create. The MTU Ping (Create) form opens. The form displays information about the service tunnel being tested and the originating tunnel ID. |
7 |
Configure the required parameters. |
8 |
Click on the Test Parameters tab and configure the required parameters. Note: If the step size is small but the end message size is large, the amount of time to complete the MTU ping may be many minutes. Ensure that you have an appropriate step size that reflects the range of MTU packet sizes that you want to test. |
9 |
Click on the Results Configuration tab and configure the required parameters. |
10 |
Click Apply to save the changes. |
11 |
Perform the MTU ping.
|
12 |
Close the Tunnel (Edit) form when the OAM diagnostics are complete. End of steps |