To create and run an MFIB ping OAM diagnostic test from the STM
Steps
1 |
Choose Tools→Service Test Manager (STM) from the NFM-P main menu. The Service Test Manager form opens. |
2 |
Click Create and choose Multicast→MFIB Ping. The MFIB Ping (Create) form opens. |
3 |
Configure the required parameters on the General tab. When the Service Name parameter is configured, you can configure the Name parameter for the site. When you set the target IP address, then choose a service ID, only service IDs from the selected site are available. |
4 |
Click on the Test Parameters tab and configure the required parameters. |
5 |
Click on the Results Configuration tab and configure the required parameters. |
6 |
Save the changes and close the forms. |
7 |
To run the OAM diagnostic test and view the results, perform To run one or more OAM diagnostic tests from the STM and view the test results . See To interpret OAM diagnostic test results on the STM for information about how to interpret the test results. End of steps |