To create and run an ICMP ping OAM diagnostic test from the STM
Steps
You can also perform an ICMP ping test from the Test tab of a VPRN or EIS service configuration form.
1 |
Choose Tools→Service Test Manager (STM) from the NFM-P main menu. The Service Test Manager form opens. |
2 |
Click Create and choose ICMP→ICMP Ping. The ICMP Ping (Create) form opens. |
3 |
Configure the required parameters. |
4 |
Click on the Test Parameters tab and configure the required parameters. The Probe History parameter is only configurable when the NE Schedulable parameter is enabled. The Continuous Execution option is only applicable when the Packet Interval is set to 1 second or greater. The Continuous Execution and Rapid options are mutually exclusive. |
5 |
Click on the Results Configuration tab and configure the required parameters. |
6 |
Save the changes and close the forms. |
7 |
To run the OAM diagnostic test and view the results, perform To run one or more OAM diagnostic tests from the STM and view the test results . See To interpret OAM diagnostic test results on the STM for information about how to interpret the test results. End of steps |