To configure a VXLAN termination on a VPRN

Purpose

Use this procedure to configure VXLAN tunnel termination on a VPRN site. The address terminating the VXLAN tunnels can be an IPv4 or IPv6 address. An FPE must be created and configured to terminate on the VPRN, with an SPD ID range configured and VXLAN termination enabled. See To create an FPE.

Steps
 

Choose Manage→Service→Services from the NFM-P main menu. The Manage Services form opens.


Choose a VPRN service and click Properties. The VPRN Service (Edit) form opens.


On the service navigation tree, expand the Sites icon, right-click on a routing instance and choose Properties. The VPRN Site (Edit) form opens.


Create a VXLAN tunnel termination:

  1. Click on the Routing tab, then the VXLAN Tunnel Termination sub-tab.

  2. Enter the tunnel termination IP address.

  3. In the FPE panel, click Select and choose the FPE ID.

  4. Click Apply and close the form.


Close the forms.

End of steps