How to mark and drill the anchor holes

Mark and drill the anchor holes

Important!  Procedures for the preparation of the mounting surfaces shall be performed as part of site preparation.

Task StepsUse the following procedure to mark and drill the anchor holes in a concrete surface.

1

Mark the surface for all cabinets to be installed. Refer to the anchor footprint diagrams on the previous pages for cabinet anchoring dimensions.


2

Drill the anchor holes to the proper size and depth as specified in Anchoring specifications.

Important!  If a 4-inch hole depth cannot be attained for a 12-mm expansion stud anchor (seismic zones 3 and 4), a spacer may be removed from the anchor assembly when it is installed. The minimum depth of the hole is 3 inches.


3

Tape over the open holes to prevent debris from falling inside.

Important!  Do not install the anchors at this time. Anchors will be installed later by equipment installers.

End of steps



© Alcatel-Lucent