1

Attach L-Bracket, Item 1b, to customer supplied vertical pipe using bolts (Items 5b or v 6b to suit) and Items 4b, 7b and 8b. Locate in desired position.

2

Tighten 0.25 inch hardware.

3

With a Gasket, Item 2, on top of the L-Bracket, insert cable assembly through L-Bracket and Gasket. Attach the cable assembly to the GPS antenna and tighten the connector as required.

4

Insert the four short, Item 3b, screws through the L-Bracket and Gasket and attach antenna and tighten screws. Do not use the Captive Screws for this configuration.

5

Install weatherproofing that extends at least 2 inch below the bottom of the connector on the cable assembly to directly underneath the base plate of the antenna.

Important!  Weatherproofing is not provided with this kit.

End of steps

1

Install captive screws (3a) and set screws (4a) in collar (1a), then push captive screws (3a) through gasket holes to retain gasket (2).

2

Insert the cable assembly fitted with N male connector through customer-supplied vertical mounting pipe, and collar and gasket assembly, prepared previously.

3

CAUTION

Service-disruption hazard

The antenna connection can be damaged if attached or removed incorrectly.

Do not twist antenna to attach or remove cable.

Attach cable assembly to the GPS antenna and tighten connector as required.

4

Attach Collar and Gasket assembly to antenna and tighten captive screws, Item 3a, into antenna base.

5

Slide assembly down so that the Collar slides over the mounting pipe. Tighten set screws, Item 4a.

6

Install weatherproofing that extends from directly underneath the flange on the collar bracket to at least 3 inches below the bottom of the collar measured on the cable assembly.

Important!  Weatherproofing is not provided with this kit.

End of steps