Routing protocol configuration workflow

Stages
 
1 

Configure a base routing instance or VRF instance on a device; see To configure a routing instance or a VRF instance .

2 

Enable the routing protocols to be supported on the device or routing instance. The supported protocols are device dependent. The options are:

Note: L2TP is enabled by default on a base routing instance, but not on a VPRN routing instance.

3 

Configure L3 network interfaces as required if you need to enable multicast routing protocols. See the Workflow to configure NE routing and forwarding in Chapter 27, NE routing and forwarding .

4 

Configure the appropriate routing policies as required; see Chapter 54, Routing policies .

5 

Review the following protocol workflows as required to configure additional functionality:

  1. BGP and MP-BGP; see Workflow to configure BGP and MP-BGP

  2. RIP; see RIP and RIPng configuration workflow

  3. LDP; see Workflow to configure LDP

  4. IS-IS; see Workflow to configure IS-IS

  5. OSPFv2 or OSPFv3; see Workflow to configure OSPFv2 and OSPFv3

  6. RSVP; see Workflow to configure RSVP

  7. L2TP; see Workflow to configure L2TP

  8. PIM; see Workflow to configure PIM

  9. IGMP; see Workflow to configure IGMP

  10. MSDP; see Workflow to configure MSDP

  11. MLD; see Workflow to configure MLD

  12. bridging; see Workflow to configure bridging on an OmniSwitch

  13. WPP; see Workflow to configure WPP

  14. BIER; see Workflow to configure BIER

  15. IPSec; see Workflow to configure IPSec

6 

Configure routing protocol monitoring as required; see Workflow to configure BMP.

7 

Configure the protocol for the remote device as required.