To create and run a service site ping OAM diagnostic test from the STM
Steps
1 |
Choose Tools→Service Test Manager (STM) from the NFM-P main menu. The Service Test Manager form opens. |
2 |
Click Create and choose Service→Create Service Site Ping. The Service Site Ping (Create) form opens. |
3 |
Configure the required parameters. |
4 |
Click on the Test Parameters tab and configure the required parameters. When you set the target IP address, then choose a service ID, only service IDs from the selected site are available. When you set the Use Local Tunnel and Use Remote Tunnel parameters, the test becomes a ping that tests the service tunnel bindings between the service sites. |
5 |
Click on the Results Configuration tab and configure the required parameters. |
6 |
Save the changes and close the forms. |
7 |
To run the OAM diagnostic test and view the results, perform To run one or more OAM diagnostic tests from the STM and view the test results . See To interpret OAM diagnostic test results on the STM for information about how to interpret the test results. End of steps |