Advanced Stats Analysis report

Advanced Stats Analysis report overview

The Advanced Stats Analysis report shows the peak and average statistics of the UBT radio NEs along with the peak utilization, peak throughput, average utilization, and average throughput values.

Use cases

Capacity planning—Use the report to highlight ports crossing the threshold for a given time range with specified number of occurrences.

Prerequisites

The following table describes the aggregation rules that must be enabled and the accounting policies that must be configured for the NEs on which statistics are to be collected; see the NSP NFM-P Statistics Management Guide for information about configuring an accounting policy. To view the report for granularities other than raw data, the aggregation rules must be enabled; see How do I configure analytics aggregation?.

Table 15-10: Advanced Stats Analysis report prerequisites

Aggregator name

Monitored object class

Statistics class

Statistics collection

MIB

NE types

Not applicable

Port

LAG

Peak Throughput

Average Throughput

Peak Link Utilization

Average Link Utilization

Peak And Average Throughput and Link Utilization History Data Stats (24Hr)

Peak And Average Throughput and Link Utilization History Data Stats (15 min)

opticsIMPeakAndAverageHistoryDataEntry

Wavence MSS-1, Wavence MSS-4, Wavence MSS-8, Wavence MSS-E, Wavence MSS-HE, Wavence MSS-XE, Wavence UBT-SA, Wavence UBT-I, Wavence UBT-T XP, 9500 MPR-A Chassis 4, 9500 MPR-A Chassis 8, 9500 MPR-E Chassis 1, 9500 MPR-E Chassis 4, 9500 MPR-E Chassis 8

Note: The 7705 SAR-H is not supported.

Report characteristics

The following table lists the principal report characteristics.

Table 15-11: Advanced Stats Analysis report characteristics

Characteristic

Value

Data type

Statistics

NSP flow collector required

No

NE types supported

Wavence MSS-1, Wavence MSS-4, Wavence MSS-8, Wavence MSS-E, Wavence MSS-HE, Wavence MSS-XE, Wavence UBT-SA, Wavence UBT-I, Wavence UBT-T XP, 9500 MPR-A Chassis 4, 9500 MPR-A Chassis 8, 9500 MPR-E Chassis 1, 9500 MPR-E Chassis 4, 9500 MPR-E Chassis 8

Report inputs

Prompt

Notes

Start date

End date

Calendar date or relative date (for example, two days ago) and time

Granularity

Aggregation types:

  • 15 Minutes

  • 24 Hours

Statistics

Statistics types:

  • Peak Throughput

  • Average Throughput

  • Peak Link Utilization

  • Average Link Utilization

Threshold (Mbps or %)

Specify the threshold value.

Minimum Number of Occurrences

Specify the number of occurrences.

Logo Resource ID

The logo to add to the report. Enter the Resource ID of the logo image in the Images folder. The default is the Nokia logo. To create the report without a logo, leave the Logo Resource ID field blank.

Logo Position

Choose Left, Middle, or Right. The logo appears on the left on the first page of the report if you choose Left or Middle.

Show report output on one page

Select the check box to enable pagination.

Note: Using the Show report output on one page option when creating reports as drill-downs may impact report rendering time. Nokia recommends disabling the Show report output on one page option when creating reports.

Apply

Applies all the parameters and prepares the report based on the parameters entered.

Reset

Resets all the parameters to default value.

Drill-down support

No

Example

The following figure shows a report example.

Figure 15-11: Advanced Stats Analysis Report
Advanced Stats Analysis Report