Choose Tools→Route Analysis→Path and Prefix Monitoring from the NFM-P main menu. The Path and Prefix Monitoring form opens.

Click on the Create button and choose P2MP LSP Path Monitor. The P2MP LSP Path Monitor (Create) form opens with the General tab displayed.

Configure the parameters:

• Name

• Description

• Monitor State

Configure the ID parameter in the LSP panel.

Click on the Apply button to save the configuration. The CPAM monitors the path only if the Monitor State is set to Up.

Click on the Auto OAM tab button. The General tab is displayed.

Click on the Select button in the STM Policy panel to associate a test policy to the IP path monitor. The Select STM Policy - LSP Path Monitor form opens.

Click on the Search button. A list of configured test policies appears.

Choose an entry and click on the OK button. The Select STM Policy - LSP Path Monitor form closes.

Click on the Select button in the Execution Policy panel to associate an execution policy to the P2MP LSP monitor. The Select Execution Policy - P2MP LSP Path Monitor form opens.

Click on the Search button. A list of configured execution policies appears.

Choose an entry and click on the OK button. The Select Execution Policy - P2MP LSP Path Monitor form closes.

Note: See To configure an OAM test execution policy for information about how to create an execution policy.

See To manually run an OAM diagnostic on an IP, LSP, or P2MP path monitor or information about how to run an OAM test.

Click on the S2L Paths tab button to view monitored S2L paths.

Note: You can click on the Capture Path button to perform an immediate path capture.

Click on the Path History tab button to view monitored IP paths.

Note: You can click on the Capture Path button to perform an immediate path capture. If the Capture Path button is not visible, click on the More Actions button and choose Capture Path.

Close the P2MP LSP (Create) form.

Close the Path and Prefix Monitoring form.

End of steps