To configure bulk changes for performance management statistics

Steps
 

Choose Tools→Bulk Operations from the NFM-P main menu. The Bulk Operations form opens.


Click Create. The Create Bulk Change step form opens.


Configure the required parameters in the General step and click Next. The Specify the filter step appears.


Configure an appropriate filter in the Specify the filter step and click Next. The Specify the attributes step appears.


Expand the Attributes drop-down, and click on one or more attributes, as required. The PM properties are displayed on the right panel.


Configure the parameters in the right panel.

The following notes apply:

  • For radio interfaces, do not use the following attributes:
    • Radio: Radio Port (Radio Equipment)→Radio PM : Radio Port (Radio Equipment)→Radio PM.

      The configured filter lists only the enabled radio PM statistics and not the disabled radio PM statistics.

    • Radio: Radio Port (Radio Equipment)→Radio PM : Radio Port (Radio Equipment)→Radio Bulk Radio PM Enable/Disable 15 Min

    • Radio: Radio Port (Radio Equipment)→Radio PM : Radio Port (Radio Equipment)→Radio Bulk Radio PM Enable/Disable 24 Hrs

  • For DS1/E1:
    • PM Enable/Disable for DS1 ports is supported only for Framed and

      Unframed signal mode ports.

    • PM Enable/Disable for E1 ports is supported only for Framed signal mode ports.


Click Next, then click Finish, and close the form. The Bulk Operations form reappears.


Click Search to locate the Bulk Operation task, choose an entry, and click Properties. The Bulk Change (Edit) form opens.


Click on the Batch Control tab and click Generate Batches. The batches are generated.


10 

Either click Execute All or choose the required entries and click Execute Selected to enable or disable PM statistics collection intervals of 24 hour and/or 15 min.


11 

Close the forms.

End of steps