| |
|
1 |
In the navigation tree Equipment or Routing view, right-click on a Wavence and choose Properties. The Wavence network element form opens.
|
2 |
If required, record the system IP address and management IP address for future configuration requirements.
|
3 |
If required, configure the Location and Current OLC State parameters.
|
4 |
Click on the Polling tab and configure the Scheduled Polling parameter.
|
5 |
To determine the current polling status: The read-only parameters provide the following information.
-
Resync Status indicates whether the last poll successfully completed.
-
Last Resync Start Time and Last Resync End Time indicate the start and finish of the last poll.
-
Scheduled Resync Status indicates whether the last scheduled poll successfully completed.
Note: Scheduled resynchronization is disabled, by default, for specific MIB entries. Choose the MIB entry policy in the MIB Entry Policies tab of the Administration→Mediation→Mediation (Edit) form, click Properties, then configure the Polling Interval parameter to enable scheduled resynchronization.
Enabling scheduled resynchronization of the MIB entries for which the scheduled resynchronization is set to disabled by default may have a performance impact.
-
Last Scheduled Resync Start Time and Last Scheduled Resync End Time indicate the start and finish of the last scheduled poll.
|
6 |
Save your changes and close the form.
End of steps |