To resolve Wavence MIB inconsistencies

Purpose

Perform this procedure to resolve NE inconsistencies created due to MIB population failures that can occur during service creation on a Wavence NE. If there are NE inconsistencies, the Cleanup Inconsistencies button on the Wavence network element form becomes active to provide a visual cue that action is required to resolve them.

Nokia recommends that inconsistencies be resolved before any service creation. For failures during Wavence service creation, perform a resynchronization of the NE to restore existing NE entries. Inconsistencies are detected during NE synchronization or when opening the NE Properties form. If there are inconsistencies, an alarm with a Warning severity level on the NE appears.

Steps
 

In the navigation tree Equipment view, right-click on a Wavence and choose Properties. The Wavence network element form opens.


Click Cleanup Inconsistencies. NFM-P attempts to resolve the NE MIB inconsistencies.


To verify all MIB NE inconsistencies are resolved, click on the Faults tab to check for any remaining inconsistency alarms.


Click on the Abnormal Conditions tab to check for abnormal conditions on the Wavence, such as loopback or TxMute conditions, and to determine the appropriate corrective actions.

Note: You must refresh the Abnormal Conditions tab to ensure the latest content is displayed.

Note: You can clear the abnormal condition alarm after all the individual abnormal conditions are cleared.


Close the form.

End of steps