To configure a 9500 Radio Interface Queue Map policy

General information

When configuring a 9500 Radio Interface Queue Map policy, the following QoS variants are supported: ODU, MPT-HL, and MPT-HC/MPT-MC.

Steps
 

Choose Policies→QoS→9500 MPR QoS→ 9500 Radio Interface Queue Map from the NFM-P main menu. The 9500 Radio Interface Map Policies form opens.


Perform one of the following:

  1. Configure the Policy scope parameter to Global. Go to Step 3.

  2. Configure the Policy scope parameter to Local.

    If required:

    1. Click Select to configure the Local Node IP Address parameter. The Select a Network Element form opens.

    2. Choose a device and click OK. The 9500 Radio Interface Map Policies form reappears.


Click Create. The 9500 Radio Interface Queue Map, Global Policy (Create) form opens.


Configure the parameters as required.


Click on the Radio Interface Queue Map tab and click Create. The Radio Interface Queue Map, 9500 Radio Interface Queue Map Global Policy (Create) form opens.


Configure the parameters as required and click OK. The 9500 Radio Interface Queue Map, Global Policy (Create) form reappears.

Note: You cannot configure the queue size parameters when the Reset all Queues parameter is selected.

Note: The Queue Size parameter configuration must be limited to a maximum of 4034836 bytes and a minimum of 2480 bytes.


Save your changes and close the form. The 9500 Radio Interface Map Policies form reappears.


Click Search to display the created policy. To distribute the 9500 Radio Interface Map policy, see the “Policies overview” chapter in the NSP NFM-P Classic Management User Guide.

End of steps