To configure a loopback test on Wavence ports

Supported card ports

You can configure a loopback test on Wavence ports on the following cards:

  • 1 x Radio modem

  • DS1

  • ES1

  • MPT-HCv2

  • MPT-HLC

  • MPT-HLS

  • MPT-HLv1

  • MPT-HQAM

  • STM

  • UBT-SA/T/S/m

Note: If the card containing the ports is configured but not equipped, a loopback test cannot be performed on the physical ports of the card.

Steps
 
1 

In the navigation tree Equipment view, right-click on a supported Wavence port and choose Properties. The Physical Port (Edit) form opens.

2 

Click on the Loopback tab, select an interface, and click Properties. The Loopback (Edit) form opens.

3 

Configure the parameters as required and click OK. The Physical Port (Edit) form reappears.

4 

Save your changes and close the form.

End of steps