To configure a SAP access ingress policy

Steps
 
1 

Choose Policies→QoS→SROS QoS→Access Ingress→SAP Access Ingress from the NFM-P main menu. The SAP Access Ingress Policies form opens.

2 

Click Create or choose a policy and click Properties. The SAP Access Ingress Policy (Create|Edit) form opens.

3 

Configure the required general parameters.

Note: For some of the general parameters, additional fields will be displayed when certain selections are made. For example, when setting the IP Criteria Type and IPv6 Criteria Type to VXLAN-VNI and then clicking Apply, the Match Criteria field is displayed, and shows a value of None.

Note: NEs that support next-generation CLI use the policy name as the key identifier for internal system reference. For policies on these NEs, you must configure a policy name (typically the service name or a numerical string). Policy IDs are also supported. You must configure a numerical range on the NE for auto-assigned policy IDs; see To configure an Auto-ID range for policies.

Note: For some of the following steps, the tabs are not available until after the policy is created. Click Apply if required to create the policy and make all tabs available.

4 

Map ingress dot1p bits.

  1. Click on the Dot1p tab.

  2. Click Create or choose a Dot1p entry and click Properties. The Dot1p (Create|Edit) form opens.

  3. Configure the required parameters.

  4. Save your changes and close the form.

5 

Map ingress DSCP bits.

  1. Click on the DSCP tab.

  2. Click Create or choose a DSCP entry and click Properties. The DSCP (Create|Edit) form opens.

  3. Configure the required parameters.

  4. Save your changes and close the form.

6 

Click OK to save the policy and close the form, or click Apply to save the policy. To distribute the SAP access ingress policy, see the “Policies overview” chapter in the NSP NFM-P Classic Management User Guide.

End of steps