To configure a static route

Steps
 

Right-click on the Static Routes object on the navigation tree and choose Create Static Routes. The Static Route (Create) form opens.


Configure the required parameters.

Perform one of the following based on whether you need to create a next hop or black-hole static route:

  1. To configure next hop:

    • Configure the Destination IP address, then select Next Hop from the drop-down menu, and configure the next hop IP address. Click OK to save and close the form.

    • Configure the System parameter as Local for local static routes, then configure the Next Hop IP parameter.

    Note: You can configure IPv6 destination IP address only when the IPv6 Allowed check-box is enabled on the associated L3 access interface, on the General tab of the VPRN L3 Access Interface (Edit) form.

    Note: If an IPv6 address is configured under destination IP address parameter, you can either provide an IPv6 IP address without selecting the L3 access interface or select the created L3 access interface to provide link local address under the Next Hop IP address.

  2. To configure black-hole static route, see To create a black-hole route .


Configure the remaining parameters.


Save your changes.

The Remote System or Next-Hop objects are displayed on the navigation tree below the Static Routes object for each site.


Close the forms.

End of steps