|
|
1 |
Open Device Management, Configuration Deployments.
|
2 |
Choose a physical deployment and click (Table row actions), Distribute.
The form opens with the template already selected.
|
3 |
In the Deploy Physical Configuration form, change the template as needed:
Click REPLACE, select the new template and click ADD.
|
4 |
Add one or more targets:
-
Click TARGET and choose Ports or Predefined Groups from the drop-down list.
-
Choose one or more targets from the list to add them to the Bin. You can use Shift-click to choose a range of targets.
-
Verify the list of targets in the Bin and click ADD.
-
To add additional targets, repeat the previous steps and click UPDATE.
Note: All targets must be the same type, that is, you can’t deploy to Ports and Predefined Groups in the same deployment.
|
5 |
If the template is flexible, the VIEW/EDIT TEMPLATE CONFIG button is available.
-
Click VIEW/EDIT TEMPLATE CONFIG to open the View/Edit Template Config form.
-
Choose a template and click Edit Configuration.
-
In the form that opens, configure the template parameters.
-
Click UPDATE if you made changes, or click CANCEL to close the Edit Configuration form.
-
Update additional template configurations as needed.
-
Click SAVE if you made changes, or click CANCEL to close the View/Edit Template Config form.
If the template is fixed, click the VIEW TEMPLATE CONFIG button for a read-only preview of the configuration parameters.
|
6 |
Complete the creation of the new deployment:
-
Click SAVE to add the deployment to the list in Saved status, but not apply the configuration to the targets.
-
Click DEPLOY to apply the configuration to the targets.
End of steps |