To create and run VCCV trace OAM diagnostic test from the STM
Steps
You can also perform this diagnostic test from a VLL service form, or from the service flat topology map. To create a VCCV trace OAM diagnostic test from a static PW to a dynamic PW segment, perform To create and run a VCCV trace OAM diagnostic from a static PW to a dynamic PW segment from the STM . To create a VCCV trace OAM diagnostic test from a dynamic PW to a static PW segment, perform To create and run a VCCV trace OAM diagnostic from a dynamic PW to a static PW segment from the STM .
1 |
Choose Tools→Service Test Manager (STM) from the NFM-P main menu. The Service Test Manager form opens. |
2 |
Click Create and choose Service→VCCV Trace. The VCCV Trace (Create) form opens. |
3 |
Configure the required parameters. |
4 |
Set the Test Type parameter in the Test Object panel to Regular. |
5 |
Select a spoke SDP binding in the First Spoke SDP Binding panel. |
6 |
Configure the required parameters. |
7 |
Set the Target FEC Type parameter to None. |
8 |
Click on the Test Parameters tab and configure the required parameters. The Probe History parameter is only configurable when the NE Schedulable parameter is enabled. If you are configuring a VCCV trace test for a VLL with a switching site, you must set the Reply Type parameter to IP. |
9 |
Click on the Results Configuration tab and configure the required parameters. |
10 |
Save the changes and close the forms. |
11 |
To run the OAM diagnostic test and view the results, perform To run one or more OAM diagnostic tests from the STM and view the test results . See To interpret OAM diagnostic test results on the STM for information about how to interpret the test results. End of steps |