Create a service tunnel template

Perform this procedure to create the template that Service Management will use in the creation of a service tunnel.

This procedure is based on the procedure to create a tunnel template in the NSP Service Management Guide.

For example, the reference procedure in NSP 23.11 is How do I create a tunnel template?.

From the Service Management, Tunnel Templates view, click CREATE.

The Create a tunnel template form opens.

Configure the parameters, as required.

Parameter	Description
Template Name	Specifies the name of the template
Description	Describes the template
Tunnel Intent Type	`tunnel`
Intent Version	Specifies which version of the selected tunnel intent type to associated with the template
State	Released
Config Form	Specifies the form to be used for the template

If required, click ADD in the Workflows panel to add workflows to the tunnel template.

The Add Workflows form opens.

Configure the parameters, as required:

Parameter	Description
Workflow Name	Specifies the workflow to be executed
Service Life Cycle State	Specifies the life cycle state of the tunnel that will trigger workflow execution
Service Life Cycle Case	Specifies the case, Success or Fail, relative to the life cycle state that will trigger workflow execution
Blocking	Specifies whether unsuccessful execution of the workflow will prevent tunnel life cycle state changes
Workflow Execution Timeout (seconds)	Specifies the length of time, in seconds, that unsuccessful execution of the workflow will prevent tunnel life cycle state changes

Click ADD.

The Add Workflows form closes and the workflow is added to the tunnel template.

Click CREATE.

The tunnel template is created.

End of steps