Reference
Documents under this category include information about the attributes, APIs, and the full set of CLI commands (MD-CLI and classic) supported by SR OS.
- Acronyms Guide
  This guide provides expansions of acronyms found in the user guides.
- Classic CLI Command Reference Guide
  This guide describes all classic CLI commands (except for the clear, monitor, show, and tools commands) and their supported values and parameters.
- Clear, Monitor, Show, and Tools CLI Command Reference Guide
  This guide describes all clear, monitor, show, and tools CLI commands and their supported values and parameters.
- MD-CLI Command Reference Guide
  This guide describes all MD-CLI commands (except for the clear, monitor, show, and tools commands) and their supported values and parameters.
- MD-CLI Quick Reference Guide
  This guide provides a comparison of the Nokia SR OS Model-Driven Command Line Interface (MD-CLI) with those used by Junos OS and IOS XR.

x Commands

xc

Syntax

xc [detail]

no xc

Context

[Tree] (debug>router>mpls>event xc)

Full Context

debug router mpls event xc

Description

This command debugs cross connect events.

The no form of the command disables the debugging.

Parameters

detail: Displays detailed information about cross connect events.

Platforms

7705 SAR Gen 2

xgig

Syntax

xgig {lan | wan}

Context

[Tree] (config>port>ethernet xgig)

Full Context

configure port ethernet xgig

Description

This command configures a 10 Gb/s interface to be in Local or Wide Area Network (LAN or WAN) mode. When configuring the port to be in WAN mode certain SONET/SDH parameters can be changed to reflect the SONET/SDH requirements for this port.

When the port is configured for LAN mode, all SONET/SDH parameters are pre-determined and not configurable.

Default

xgig lan

Parameters

lan: Sets the port to operate in LAN mode.

wan: Sets the port to operate in WAN mode.

Platforms

7705 SAR Gen 2

April 25, 2025