Result codes (Result-Code AVP)
Result code ID | Result code name | Description |
---|---|---|
Success |
||
2001 |
DIAMETER_SUCCESS |
The request was successfully completed. |
Protocol errors |
||
3001 |
DIAMETER_COMMAND_UNSUPPORTED |
Rx: treated as an error. Tx: not supported. |
3002 |
DIAMETER_UNABLE_TO_DELIVER |
Rx: peer failover procedure on the Diameter base level is invoked. After the same response (3002) is received from all eligible peers, the application level (NASREQ/Gx/Gy) is notified. The message can then be retransmitted one last time with the destination-host AVP cleared. For a message to be retransmitted on the application level, server failover procedure must be enabled. Tx: diameter base replies with 3002 if it cannot route the received request message to its destination (this applies to Diameter multichassis configuration). |
3003 |
DIAMETER_REALM_NOT_SERVED |
Rx: treated as an error. Tx: not supported. |
3004 |
DIAMETER_TOO_BUSY |
Rx - The peer failover procedure on the Diameter base level is invoked. After the same response (3004) is received from all eligible peers, the application level (NASREQ, Gx, Gy) is notified. The message can then be retransmitted one last time with the destination-host AVP cleared. For a message to be retransmitted on the application level, server failover procedure must be enabled. Tx: not supported. |
3005 |
DIAMETER_LOOP_DETECTED |
Rx: treated as an error. Tx: not supported. |
3006 |
DIAMETER_REDIRECT_INDICATION |
Rx: treated as an error. Tx: not supported. |
3007 |
DIAMETER_APPLICATION_UNSUPPORTED |
Rx: treated as an error. Tx: not supported. |
3008 |
DIAMETER_INVALID_HDR_BITS |
Rx: treated as an error. Tx: not supported. |
3009 |
DIAMETER_INVALID_AVP_BITS |
Rx: treated as an error. Tx: not supported. |
3010 |
DIAMETER_UNKNOWN_PEER |
Rx: treated as an error. Tx: not supported. |
Permanent failures |
||
5001 |
DIAMETER_AVP_UNSUPPORTED |
Rx: treated as an error. Tx: Reception of an unrecognized AVP with M-bit set triggers a response (RAA) message that contains the Result-Code AVP whose value is set to DIAMETER_AVP_UNSUPORTED, and the Failed-AVP AVP containing the offending AVP. |
5002 |
DIAMETER_UNKNOWN_SESSION |
Rx: treated as an error. Tx: In case that a message from PCRF is received for a non-existing session, the 7750 SR replies with this value. |
5004 |
DIAMETER_INVALID_AVP_VALUE |
Rx: treated as an error. Tx: Reception of an AVP with invalid value triggers a response message (RAA) that contains the Result-Code AVP whose value is set to DIAMETER_INVALID_AVP_VALUE, and the Failed-AVP containing the AVP that caused the error. |
5005 |
DIAMETER_MISSING_AVP |
Rx: treated as an error. Tx: not supported. |
5007 |
DIAMETER_CONTRADICTING_AVPS |
Rx: treated as an error. Tx: not supported. |
5008 |
DIAMETER_AVP_NOT_ALLOWED |
Rx: treated as an error. Tx: not supported. |
5009 |
DIAMETER_AVP_OCCURS_TOO_MANY_TIMES |
Rx: treated as an error. Tx: not supported. |
5010 |
DIAMETER_NO_COMMON_APPLICATION |
Rx: treated as an error. Tx: not supported. |
5011 |
DIAMETER_UNSUPPORTED_VERSION |
Rx: treated as an error. Tx: As an example, a RAA message carries this AVP as a response to a RAR message that was received by a SR OS node while the Gx session was in a session terminating state. A session terminating state is considered a state where the SR OS node is waiting for a CCA-T message as a response to a previously initiated CCR-T message by the SR OS node. |
5012 |
DIAMETER_UNABLE_TO_COMPLY |
Rx: treated as an error. Tx: For example, a RAA message carries this AVP as a response to a RAR message that was received by a SR OS node while the Gx session was in a session terminating state. A session terminating state is considered a state where the SR OS node is waiting for a CCA-T message as a response to a previously initiated CCR-T message by the SR OS node. |
5013 |
DIAMETER_INVALID_BIT_IN_HEADER |
Rx: treated as an error. Tx: not supported. |
5014 |
DIAMETER_INVALID_AVP_LENGTH |
Rx: treated as an error. Tx: not supported. |
5015 |
DIAMETER_INVALID_MESSAGE_LENGTH |
Rx: treated as an error. Tx: not supported. |
5016 |
DIAMETER_INVALID_AVP_BIT_COMBO |
Rx: treated as an error. Tx: not supported. |
5017 |
DIAMETER_NO_COMMON_SECURITY |
Rx: treated as an error. Tx: not supported. |
Gx specific permanent failures |
||
5140 |
DIAMETER_ERROR_INITIAL_PARAMETERS |
Rx: treated as an error. Tx: not supported. |
5141 |
DIAMETER_ERROR_TRIGGER_EVENT |
Rx: treated as an error. Tx: not supported. |
5142 |
DIAMETER_PCC_RULE_EVENT |
Rx: treated as an error. Tx: not supported. |
5148 |
DIAMETER_ADC_RULE_EVENT |
Rx: treated as an error. Tx: not supported. |