Replace a Lucent CM server

Replace a Lucent CM server
		GO

This topic describes the steps to replace a Lucent CM server that is currently used in an active Lucent CM system.

The following replacement scenarios are supported:

Replace a Sun^® Fire^TM X2100 M2 server by a Sun^® Fire^TM X2100 M2 server.

Replace a Sun^® Fire^TM X2100 server by a Sun^® Fire^TM X2100 server or a Sun^® Fire^TM X2100 M2 server.

Replace a Sun^® Fire^TM V20z server by a Sun^® Fire^TM V20z server, a Sun^® Fire^TM X2100 server, or a Sun^® Fire^TM X2100 M2 server.

Procedure 1	Refer to
Hardware installation	Sun Fire^TM X2100 M2 Server Installation Guide
Cabling
Power up
Power down

Notes:

1	Some procedures are also available in other X2100 M2 guides.

Procedure 1	Refer to
Hardware installation	Sun Fire^TM X2100 Server Getting Started Guide
Cabling
Power up
Power down

Notes:

1	Some procedures are also available in other X2100 guides.

Procedure 1	Refer to
Hardware installation	Sun Fire^TM V20z and Sun Fire^TM V40z Servers Installation Guide
Cabling
Power up
Power down	Sun Fire^TM V20z and Sun Fire^TM V40z Servers User Guide

Notes:

1	Some procedures are also available in other V20z guides.

Perform the following steps:

1	Backup the Lucent CM system. Reference: Refer to the topic Backup the Lucent CM system.
2	Stop the server. Reference: Refer to the topic Start and stop a server.
3	Perform the following steps to remove the server hardware: Power off the server. Disconnect the cables. Remove the server. Reference: Refer to the server hardware documentation.
4	Perform the following steps to install the new server hardware: Install the server. Reconnect the cables. Power on the server. Reference: Refer to the server hardware documentation.
5	Install Red Hat Linux. Reference: Refer to the chapter Lucent CM system installation.
6	Recover the node, to re-establish the existing provisioning of the node. Reference: Refer to the topic Recover a Node. End of steps

		GO
© Lucent Technologies