Procedure 5-123: Clear "Ring Prot Switching Suspended" alarm
Before you begin
Prior to performing this procedure:
-
Refer to Before you begin and Required equipment in this chapter.
-
Refer to Laser safety and Electrostatic discharge in Chapter 1, Safety.
Steps
Complete the following steps to clear a Ring Prot Switching Suspended alarm.
1 |
From the WaveStar® CIT System View, click the Alarm List button and locate the Ring Prot Switching Suspended condition in the resulting alarm list and note the corresponding AID. | ||||||
2 |
Is there a Lockout Switch condition listed?
| ||||||
3 |
Is a new node being added to the ring?
| ||||||
4 |
From the System View, select View → Ring Map → Ring Map. Select the required ring and click Select. Verify that the ring map was provisioned correctly. Result: The Ring Map window opens. | ||||||
5 |
Is either the West Link or the East Link Isolated?
| ||||||
6 |
Clear any BLSR-related alarms or conditions present in the alarm list. | ||||||
7 |
From the System View, click the Alarm List button and click Refresh. Result: The Ring Prot Switching Suspended alarm is no longer present. End of steps |