Procedure 5-12: Clear "CP removed or CP failure" alarm
Before you begin
Prior to performing this procedure:
-
Refer to Before you begin and Required equipment in this chapter.
-
Refer to Laser safety and Electrostatic discharge in Chapter 1, Safety.
Steps
Complete the following steps to clear a CP removed or CP failure alarm.
1 |
From the WaveStar® CIT System View, click the Alarm List button and locate the CP removed or CP failure alarm in the resulting alarm list. | ||||||
2 |
Determine the alarm level(s) for the active CP removed or CP failure alarm(s). Clear the alarms in order of severity. | ||||||
3 |
Refer to the Probable Cause column in the alarm list and note the corresponding slot AID. | ||||||
4 |
Important! The CP removed or CP failure alarm is reported when a circuit pack is removed from a slot or when a slot is equipped with a circuit pack that has a failed power module. Locate the required slot and determine if a circuit pack is physically present in the required slot. | ||||||
5 |
Is a circuit pack physically present in the required slot?
| ||||||
6 |
Using office records, determine if the required slot should contain a circuit pack. | ||||||
7 |
Do office records show that the required slot should contain a circuit pack?
End of steps |