Procedure 8-7: Schedule performance monitoring (PM) reports
Overview
This procedure allows a user to schedule Performance Monitoring reports on Alcatel-Lucent 1850 TSS-5. Performance monitoring can be scheduled to provide quarter hour and daily reports beginning at different time intervals.
In order to schedule PM reports, PM messaging must be enabled and you must use the WaveStar® CIT TL1 cut-through mode.
Important!
The WaveStar® CIT Graphical User Interface (GUI) does not, at this time, support this command.
If you are unfamiliar with the parameters in this procedure, refer to SCHED-PMREPT in the Alcatel-Lucent 1850 Transport Service Switch (TSS-5) TL1 Command Guide for MSPP.
Privilege level
You must log in as a Privileged, General, or Maintenance user to complete this procedure.
Before you begin
Prior to performing this procedure, refer to Before you begin and Required equipment in this chapter.
Steps
Complete the following steps to schedule PM. The NE supports up to a maximum of 100 active scheduled PM reports, counting every aid as many times as it is scheduled (aid values that include ALL are counted multiple times). The NE accepts each SCHED-PMREPT as a request for a different scheduled PM report unless two requests are exact duplicates. The SCHED-PMREPT command does not generate a REPT DBCHG message.
1 |
Important! The port/tributary/VCG monitoring mode parameter must be IS (in-service) to enable performance monitoring. Verify that performance monitoring is enabled (port/tributary/VCG monitoring mode is IS) for the required port, tributaries, and/or VCGs. Reference: Procedure 8-4: View performance monitoring (PM) settings | ||||||
2 |
From the WaveStar® CIT System View menu, select Administration → Set TL1 Message Map to obtain the TL1 Message Type List and verify that the Performance Monitoring (PM) message type has been enabled for the OS Application Type. Reference: Procedure 7-16: Map TL1 message types to OS applications | ||||||
3 |
The OSI and LAN connection support multiple login sessions. | ||||||
4 |
From the WaveStar® CIT System View menu, select File → NE Disconnect and click Yes in the resulting confirmation window. | ||||||
5 |
From the Network View, establish another login session, but this time click TL1, not Graphical. | ||||||
6 |
Select the Cut Through Execution Mode and click OK. | ||||||
7 |
Log in to the network element using the act-user TL1 command. Enter your user ID and password. Defaults are ALU01 and 1850TSS-5, respectively. | ||||||
8 |
Schedule the required PM report using the sched-pmrept TL1 command. Reference: Alcatel-Lucent 1850 Transport Service Switch (TSS-5) TL1 Command Guide for MSPP End of steps |