To configure network interfaces on a CPM virtual routing instance

Purpose

Perform this procedure to re-configure network interfaces created in To create a network interface on a CPM virtual routing instance or to configure interfaces that are associated with a CPM virtual routing instance but not previously configured.

Steps
 

In the navigation tree routing view, expand Network→NE→Routing Instance→Interface.


Right-click on the interface that you want to configure and choose Properties. The Network Interface (Edit) form opens.


Click on the appropriate tab and configure the parameters as required. Table 27-2, CPM virtual routing instance network interface form tabs describes the tabs you can use to modify an existing routing interface.

Table 27-2: CPM virtual routing instance network interface form tabs

Tab

Description

General

To configure the general parameters associated with the network interface.

Port

To create an association between the network interface and a physical port or channel. The system interface is not associated with a port.

Addresses

To assign an IP address and subnet to a network interface. Only one primary IP address can be associated with a network interface.

Statistics

To view the statistics associated with the network interface.

TCA

To assign a TCA policy to a network interface. See To configure a TCA policy to create a TCA policy.

Deployment

To monitor the deployment status of the interface such as any warnings when a configuration change is not fully deployed to an NE.

Faults

To view alarms that are raised against the network interface, or related alarms that affect the network interface.


Save your changes and close the form.

End of steps