Routing protocol configuration workflow

Stages
 

Configure a base routing instance or VRF instance on a device; see To configure a routing instance or a VRF instance .


Enable the routing protocols to be supported on the device or routing instance. The supported protocols are device dependent. The options are:

Note: L2TP is enabled by default on a base routing instance, but not on a VPRN routing instance.


Configure L3 network interfaces as required if you need to enable multicast routing protocols. See the Workflow to configure NE routing and forwarding in Chapter 27, NE routing and forwarding .


Configure the appropriate routing policies as required; see Chapter 54, Routing policies .


Review the following protocol workflows as required to configure additional functionality:

  1. BGP and MP-BGP; see Workflow to configure BGP and MP-BGP

  2. RIP; see RIP and RIPng configuration workflow

  3. LDP; see Workflow to configure LDP

  4. IS-IS; see Workflow to configure IS-IS

  5. OSPFv2 or OSPFv3; see Workflow to configure OSPFv2 and OSPFv3

  6. RSVP; see Workflow to configure RSVP

  7. L2TP; see Workflow to configure L2TP

  8. PIM; see Workflow to configure PIM

  9. IGMP; see Workflow to configure IGMP

  10. MSDP; see Workflow to configure MSDP

  11. MLD; see Workflow to configure MLD

  12. bridging; see Workflow to configure bridging on an OmniSwitch

  13. WPP; see Workflow to configure WPP

  14. BIER; see Workflow to configure BIER

  15. IPSec; see Workflow to configure IPSec


Configure routing protocol monitoring as required; see Workflow to configure BMP.


Configure the protocol for the remote device as required.