MPLS workflow and procedures
To enable MPLS on a routing instance
To create a segment routing TE LSP
To configure a Dynamic or segment routing TE LSP
To create a Dynamic or segment routing LSP from a tunnel template
To list Dynamic or segment routing LSPs
To view ping results on a BFD LSP session for a Dynamic LSP
To run an OAM validation test for a Dynamic or segment routing LSP
To create a Point-to-Multipoint LSP
To view an MVPN Point-to-Multipoint LSP object
To configure a Manual Bypass LSP
To create an LSP path using a tunnel template
To configure an LSP Path optimization policy
To terminate an LSP Path optimization policy that is in progress
To view LSP Path optimization policy results
To view detour and bypass path information
To view exclude route object information
To create an LSP template MVPN policy
To view LSP templates for MVPN created using CLI
To view LSPs created by One-hop P2P and Mesh P2P templates
To create an administrative LSP tag
To create an administrative tag policy
To create a reserved label block
Workflow to collect segment routing TE LSP rate PM statistics