Chapter 17: Wavence microwave backhaul L3 SNMP management


L3 network interface management

Workflow to configure L3 VPN transport setup

Workflow to configure a VPRN service using the Service Fulfillment application

To initialize an L3 VLAN ID

To configure a System and Network interface

To initialize the MPLS protocol

To configure an MPLS interface

To configure a static route

To configure a static LSP

To create static hops from an MPLS interface properties window

To configure static routes on a VPRN site

To create and configure a Two-Way Active Measurement Protocol Light reflector

To view all the configured TWAMP Light reflectors

To create an SDP Tunnel

To create a black-hole route

To configure a SAP access ingress policy

To configure a SAP access egress policy

To configure a QoS network policy

To configure an Auto-ID range for policies

To configure a VPRN service

To configure a VLAN group

To configure OSPFv2 Router ID

Workflow to configure OSPFv2

To configure OSPFv2 instance on a Routing instance

Workflow to configure OSPFv3

To enable LFA and remote LFA on an OSPF instance

To create an OSPF area

To add a Layer 3 interface to an OSPF router

To configure OSPF segment routing and discover dynamic LSPs

To configure IP/MPLS Service Tunnel

To create and run a VPRN Ping test from a service manager form

To create and run a VPRN Ping test on a SAP

Wavence VPRN service — considerations/limitations