Service Management Tasks

This section discusses the following service management tasks:

Modifying VPRN Service Parameters

Use the CLI syntax to modify VPRN parameters.

The following example displays the VPRN service creation output.

*A:ALU-1>config>service# info
----------------------------------------------
...
    vprn 1 customer 1 create
        shutdown
        vrf-import "vrfImpPolCust1"
        vrf-export "vrfExpPolCust1"
        maximum-routes 2000
        autonomous-system 10000
        route-distinguisher 10001:1
        interface "to-ce1" create
            address 172.16.0.0/12
            sap 1/1/10:1 create
            exit
        exit
        static-route-entry 192.168.255.255/16 
            next-hop 192.168.0.0
                no shutdown
            exit
        exit
        spoke-sdp 2 create 
        exit
    exit
...
----------------------------------------------
*A:ALU-1>config>service>vprn#

Deleting a VPRN Service

A VPRN service cannot be deleted until SAPs, interface spoke SDPs, and interfaces are shut down and deleted. If protocols and/or a service spoke SDP are defined, they must be shut down and removed from the configuration as well.

Use the following CLI syntax to delete a VPRN service:

CLI Syntax:
config>service#
[no] vprn service-id [customer customer-id]
    shutdown
    [no] interface ip-int-name
        [no] sap sap-id 
        [no] spoke-sdp sdp-id:vc-id 
        shutdown
    [no] spoke-sdp sdp-id
        [no] shutdown

Disabling a VPRN Service

A VPRN service can be shut down without deleting any service parameters.

CLI Syntax:
config>service#
    vprn service-id [customer customer-id]
    shutdown
Example:
config>service# vprn 1
config>service>vprn# shutdown
config>service>vprn# exit

*A:ALU-1>config>service# info
----------------------------------------------
...
    vprn 1 customer 1 create
        shutdown
        vrf-import "vrfImpPolCust1"
        vrf-export "vrfExpPolCust1"
        autonomous-system 10000
        route-distinguisher 10001:1
        auto-bind-tunnel
           resolution-filter
               ldp
           exit
           resolution filter
        exit
        vrf-target target:10001:1
        interface "to-ce1" create
            address 172.16.0.0/12
            sap 1/1/10:1 create
                ingress
                    qos 100
                    filter ip 6
                exit
                egress
                    qos 1010
                exit
            exit
        exit
        static-route-entry 192.168.0.0/16 
            next-hop 192.168.0.1
                no shutdown
            exit
        exit
        spoke-sdp 2 create 
        exit
    exit
...
----------------------------------------------
*A:ALU-1>config>service#

Re-enabling a VPRN Service

To re-enable a VPRN service that was shut down:

CLI Syntax:
config>service#
    vprn service-id [customer customer-id]
    no shutdown