Debug Service Commands
id
Syntax
id service-id
no id service-id
Context
debug>service
Description
This command enables the debugging context for a specific service.
The no form of the command disables debugging for the service.
Parameters
- service-id
the ID that uniquely identifies a service
dhcp
Syntax
dhcp
no dhcp
Context
debug>service>id
Description
This command enables the context for DHCP debugging.
The no form of the command disables DHCP debugging.
detail-level
Syntax
detail-level {low | medium | high}
no detail-level
Context
debug>service>id>dhcp
debug>service>id>dhcp6
Description
This command enables DHCP and DHCPv6 detail level tracing.
The no form of the command disables the detail level tracing.
mac
Syntax
mac ieee-address
no mac ieee-address
Context
debug>service>id>dhcp
debug>service>id>dhcp6
Description
This command enables debugging for a specified MAC address.
The no form of the command disables debugging for the MAC address.
Parameters
- ieee-address
the MAC address
mode
Syntax
mode {dropped-only | ingr-and-dropped | egr-ingr-and-dropped}
no mode
Context
debug>service>id>dhcp
Description
This command enables the DHCP tracing mode.
The no form of the command disables the tracing mode.
sap
Syntax
sap sap-id
no sap sap-id
Context
debug>service>id>dhcp
debug>service>id>dhcp6
Description
This command enables debugging for a specific SAP.
The no form of the command disables the debugging for the SAP.
Parameters
- sap-id
the physical port identifier portion of the SAP definition. See SAP ID Configurations for a full list of SAP ID
sdp
Syntax
sdp sdp-id:vc-id
no sdp sdp-id:vc-id
Context
debug>service>id>dhcp
Description
This command enables debugging for a specific SDP.
The no form of the command disables the debugging for the SDP.
Parameters
- sdp-id
the mesh SDP or spoke SDP ID; for a mesh SDP, the VC ID is optional
- vc-id
the virtual circuit ID on the SDP ID
dhcp6
Syntax
dhcp6
no dhcp6
Context
debug>service>id
Description
This command enables the context for DHCPv6 debugging.
The no form of the command disables DHCPv6 debugging.
mode
Syntax
mode {all | dropped-only}
no mode
Context
debug>service>id>dhcp6
Description
This command enables the DHCPv6 tracing mode.
The no form of the command disables the tracing mode.
event-type
Syntax
event-type {config-change | svc-oper-status-change | sap-oper-status-change | sdpbind-oper-status-change}
no event-type
Context
debug>service>id
Description
This command enables debugging for an event type.
The no form of the command disables debugging on the event type.
sap
Syntax
sap sap-id
no sap sap-id
Context
debug>service>id
Description
This command enables debugging for a specific SAP.
The no form of the command disables debugging for the SAP.
Parameters
- sap-id
the physical port identifier portion of the SAP definition. See SAP ID Configurations for a full list of SAP IDs.
sdp
Syntax
sdp sdp-id:vc-id
no sdp sdp-id:vc-id
Context
debug>service>id
Description
This command enables debugging for a specific SDP.
The no form of the command disables the debugging for the SDP.
Parameters
- sdp-id
the mesh SDP or spoke SDP ID
- vc-id
the virtual circuit ID on the SDP ID