This chapter contains brief descriptions of the alarm messages for the Alcatel-Lucent 1665 Data Multiplexer.
Automatic protection switch mode mismatch
Automatic protection switch primary section mismatch
Automatic protection switch unused codes
Automatic protection switch unresolved transient codes
CP contributing to a pack failure
ECV - excessive code violation
ENNI signaling communication failure with peer
Equipment configuration no longer supported
Excessive Reserved Rate on RPR
Far-end protection line failure
inc. E1 sync. ref. CRC-4 MFA mismatch
inc. (from DSX) DS1 sig. failed
inc. (from DSX) DS3 sig. failed
inc. (from DSX) E1 sig. failed
inc. EC1 section trace identifier mismatch
inc. EC1 section trace identifier mismatch, diagnostic
inc. OCN section trace identifier mismatch
inc. OCN section trace identifier mismatch, diagnostic
Invalid Subshelf Configuration
Member Not Collecting/Distributing
Member Signal Unacceptable - LCAS
neighbor SYSCTL CP unavailable (nbr tid = TID)
NSAP count in L1 threshold crossed
NUT Inconsistent XC Granularity
Pluggable Transmission Module insufficient maximum rate
Pluggable Transmission Module maintenance IP
Pluggable Transmission Module removed
Port administratively disabled
Protection switching byte failure
Protection switching channel match failure
remote install/copy program IP
RPR Topology Exceeded Max Stations
RPR Topology Map Entry Invalid
Subshelf Configuration Mismatch
unexpected or failed Pluggable Transmission Module
unrecoverable hardware failure during download, replace CP
VCG Failure of LCAS Protocol (Sink)
November 2011 | Copyright © 2011 Alcatel-Lucent. All rights reserved. |